Garage Door Weather Seal Threshold -Self Adhearing-Peel & Stick-GRAY

Description

Storm Shield – Peel & Stick – Garage Door Threshold Seal
GRAY
Very easy to install, a perfect DIY project.
Combined with the seal on the bottom of the garage door, this product
will create a very good seal between the door and the floor.
ALSO AVAILABLE IN BLACK SEE OUR STORE - LINK BELOW
Garage Door Stuf eBay Store
Keeps out rodents, snakes and small pests.
Resistant to oil, gas, antifreeze and other commonly used chemical substances.
Reduces rust and moisture damage to tools and machinery.
Endures temperature extremes-wont crack, move or shatter.
Meets CA. fire marshal and CPAI-84 requirements for flame resistance.
This is a very durable product, thick yet pliable, very dense. It will provide many years of reliable service.
If your floor is uneven this will help the seal of the garage door to the floor.
If the drive or approach is sloped toward the door, this will stem the flow of water into the garage.
This product works very well at keeping debris and rodents out of the garage.
VERY easy to install:
Un plug the garage door
opener and put the door in manual operation.
Do not remove plastic covering the adhesive.
L
ay the threshold in place on the garage floor.
C
ut to length and notch at the ends around the jamb and or door track if needed.
Lower the garage door onto the threshold and adjust the threshold under the door and to the door, the hump on the threshold goes on the inside of the door against the garage door. (see photos)
Once the threshold is cut and in place, clamp the door down to hold the threshold in place and draw pencil lines on both the inside and outside edge of the threshold.
Open the door and roll up the threshold.
Using Acetone or Pine- Sol, thoroughly clean the area between the pencil lines.
This must be 100% dry before proceeding, a leaf blower will speed this up.
It is best for two people to install the threshold, one holds the rolled threshold, the other peels back the plastic cover of the adhesive a few feet at a time and positions the threshold in place using the pencil lines to keep the threshold in position. Press the threshold down every few inches.
Once the threshold is in place walk on the threshold to press it down. Then close the garage door onto the threshold and clamp it down tightly, use C clamps or vice grips on the track above a roller to hold the door down. Keep the door down for a few hours and you’re all set. Clamping the door down onto the threshold is only a precaution and will help insure that the entire length of the threshold has been pressed onto the garage floor.
Install only in temperatures 50 degrees or above.
Clean the garage door thoroughly.
Tools needed.
Utility knife, cleaner (pine sol), lint free rag & Pencil – That is all!
Instructions included.
This is a very durable product, thick yet pliable, very dense. It will provide many years of reliable service.
CAUTION:
Repairing a garage door is a dangerous task. Garage door springs are under extreme tension and require appropriate safety precautions. Realize and understand the risks before undertaking any repair. Your health and safety is the #1 concern. No amount of financial savings is worth jeopardizing your health.  Working on or around garage doors and openers could result in property damage, personal injury or death. While all efforts are made to provide accurate information and guidance, it is impossible to predict all repair circumstances. Accordingly, the user agrees that use of  all  products and information contained herein are at your own risk. In no event shall
GARAGE DOOR STUFF
or Unique Supply  & Repair be held liable for any property damage, personal injury/death, or any other loss or damage that may result from your use of the information and products provided on this site. All i
nformation
contained within this site is provided “as-is” without warranty expressed or implied. User assumes all responsibility/risk for use of information and products purchased.